Product Recall - Safety Upgrade Program   l   Press Room   l    Registration Card
VENMAR & VENMAR CONNAISSEUR RANGE HOODS INSTALLATION

Plan where and how the ductwork will be installed.

Install proper-sized ductwork, elbow(s) and roof or wall cap for the type of blower you are installing.

If using 6'' (150 mm) round ducts, use a transition (sold separately). 

NOTE : For the best ventilation performance, use a transition 3-1/4'' x 10'' to 6'' (8.25 x 25.4 to 15.24 cm), if round duct is used.      

Using a long nose pliers, remove the knock-outs for the chosen opening (vertical on top or horizontal at the back of the hood).

CAUTION
Never use a hammer and a screwdriver to punch out the vertical or horizontal discharge knock-out, because this will damage the hood internal parts.

Using (2) 1/2'' screws, secure the adapter/damper to the top or back of the hood.
Tape the adapter/damper to the hood using duct tape to seal it.



  • Run power cable to installation location.
  • Place the hood under the cabinet and slide it in position.
  • Make sure the adapter/damper assembly enters the ducting.
  • Secure the hood by tightening the screws completely.

  • Connect cable to range hood wiring using wire connectors.
  • Connect BLACK to BLACK, WHITE to WHITE, and GREEN or BARE WIRE wire to GREEN ground screw.

DO NOT FORGET TO CONNECT THE GROUND!


For more details, please refer to installation manual.